StockFetcher Forums · General Discussion · Basic Help<< >>Post Follow-up
28 posts
msg #101885
Ignore stockfetcher1109
7/30/2011 4:55:38 PM

Hello All,

This is a basic question on how to use the stockfetcher.

I am using a simple RSI / MACD Histogram filter. When do most of you run your filter and enter your trades? At the end of the day? At market open?
I am new to SF and any advise would be helpful and appreciated?


4,388 posts
msg #101886
Ignore four
7/30/2011 4:59:56 PM

1. I run filters after market close
2. Place orders that night for next day


Are you day trading, swing trading...
How tight are your stops...

993 posts
msg #101895
Ignore mahkoh
7/31/2011 3:08:37 PM

You can run filters from about 10:00 until after market close, that is what I do anyway. Because the data is delayed you will until 10:00 get yesterday's results. When you run filters intraday always be aware that you are looking at what the situation was like half an hour ago.

StockFetcher Forums · General Discussion · Basic Help<< >>Post Follow-up

*** Disclaimer *** does not endorse or suggest any of the securities which are returned in any of the searches or filters. They are provided purely for informational and research purposes. does not recommend particular securities., Vestyl Software, L.L.C. and involved content providers shall not be liable for any errors or delays in the content, or for any actions taken based on the content.

Copyright 2018 - Vestyl Software L.L.C.Terms of Service | License | Questions or comments? Contact Us
EOD Data sources: DDFPlus & CSI Data Quotes delayed during active market hours. Delay times are at least 15 mins for NASDAQ, 20 mins for NYSE and Amex. Delayed intraday data provided by DDFPlus