StockFetcher Forums · General Discussion · Help with slope command<< 1 2 >>Post Follow-up
TheRumpledOne
6,407 posts
msg #34094
Ignore TheRumpledOne
11/23/2004 11:48:22 PM

Fetcher[/*Ratio*/
set{A,abs(5 day slope Stochastic(15,3)%K)}
set{B,abs(Stochastic(15,3)%K)}
set{C,abs(Historical Volatility(20,7))}
set{r,B/C}
set{s, A*r}
set{Ratio,log(s)}
add column Ratio
ratio between 1 and 2
]



That should get you in the ball park.

StockFetcher has some limitations... you ran into them...

MAY ALL YOUR FILLS BE COMPLETE.


SurfnDestiny
78 posts
msg #34149
Ignore SurfnDestiny
11/26/2004 7:25:16 PM

I also have encountered erratic operation on the slope command. In some cases I`ve had to revert to a thousandth decimal place to fine tune results. It seems the slope command sometimes works differently, depending on the measurement you use it with. Also I`ve noticed that the scaling of a particular chart can effect the slope commands results. IE: if your analyzing the slope of a 10 day close, and different stock charts have different price scales, like every half inch is 50 cents, and the next chart shows every half inch is ten cents, it seems to effect the slope commands accuracy.


cegis
235 posts
msg #34164
Ignore cegis
11/28/2004 7:48:12 PM

Somewhere I read that a slope value of 1 indicates the value DOUBLED over the time period the slope is being taken over. (I think -1 would mean the value halved.) This would cause the slope to behave seemingly erraticly. For example, a 2 day slope will be much more sensitive than a 20 day slope. Also, a 2 day slope of 1 would be far less likely than even a 5 day slope...

HTH,

C


james549
53 posts
msg #34231
Ignore james549
12/5/2004 7:50:16 AM

Thanks RumpleOne for the help.
I am just starting to understand the differences with the corrections you made. Sorry I haven't replied sooner. Holidays. I've tryed to incorperate RSI(2) and it seems no matter how I put it in I recieve a syntax error on the filter. Any ideas?



james549
53 posts
msg #34232
Ignore james549
12/5/2004 7:57:29 AM

cegis
This helped me to understand the slope command.
http://yepher.com/~yepher/stockfetcher/command.html
Look in the right hand column for "Slope of" then click on "learn more about slope"
Hope this is a help.


StockFetcher Forums · General Discussion · Help with slope command<< 1 2 >>Post Follow-up

*** Disclaimer *** StockFetcher.com does not endorse or suggest any of the securities which are returned in any of the searches or filters. They are provided purely for informational and research purposes. StockFetcher.com does not recommend particular securities. StockFetcher.com, Vestyl Software, L.L.C. and involved content providers shall not be liable for any errors or delays in the content, or for any actions taken based on the content.


Copyright 2022 - Vestyl Software L.L.C.Terms of Service | License | Questions or comments? Contact Us
EOD Data sources: DDFPlus & CSI Data Quotes delayed during active market hours. Delay times are at least 15 mins for NASDAQ, 20 mins for NYSE and Amex. Delayed intraday data provided by DDFPlus


This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.