StockFetcher Forums · General Discussion · SUPPORT/RESISTANCE HELP<< >>Post Follow-up
8 posts
msg #113705
Ignore trosen128
5/25/2013 5:31:18 PM

Hi, how do I set a filter so that I am looking at stocks that are currently either at support or resistance, and the support/resistance lines are FLAT and not pointing up or down, acting as trend lines? I am aiming to buy at support/sell at resistance in flat markets.

179 posts
msg #113707
Ignore Cheese
5/25/2013 6:03:17 PM

You may want to start with this post by tomb.
Hope this helps.

show stocks where close is below resistance(65,10)
and resistance slope(65,10) is between -0.001 and 0.001
and close is above 1

4,688 posts
msg #113883
Ignore Eman93
6/4/2013 12:28:34 AM

This is a very cheap site for the kind of information provided. He gives you lines and that's about it. Its up to you to trade them.

You will learn in a very short time to search for what makes good support and resistance areas to trade around and you can then pick your own lines just by looking at a few charts and time frames of the instrument you want to trade.


StockFetcher Forums · General Discussion · SUPPORT/RESISTANCE HELP<< >>Post Follow-up

*** Disclaimer *** does not endorse or suggest any of the securities which are returned in any of the searches or filters. They are provided purely for informational and research purposes. does not recommend particular securities., Vestyl Software, L.L.C. and involved content providers shall not be liable for any errors or delays in the content, or for any actions taken based on the content.

Copyright 2018 - Vestyl Software L.L.C.Terms of Service | License | Questions or comments? Contact Us
EOD Data sources: DDFPlus & CSI Data Quotes delayed during active market hours. Delay times are at least 15 mins for NASDAQ, 20 mins for NYSE and Amex. Delayed intraday data provided by DDFPlus